PLASTIVERD GLOBAL is a copolymer of PET (Polyethylene-Terephthalate), delivered in resin pellets. It is suitable for stretch blow moulding in one or two stage processes, extrusion and film applications. Specially recommended for general uses in which the main requirement is the balance of optical and mechanical properties. It is particularly recommended for still or carbonated water, soft drinks, edible oil, food packaging and spirit drinks.
|Intrinsic Viscosity||dL/gr||0’80 ± 0’02||ISO 1628|
|Colour L||–||≥ 85||ASTM 6290|
|Colour b*||–||≤ 0||ASTM 6290|
|Acetaldehyde||ppm||≤ 1||ASTM F2013|
|Specific Density Crystalline||g·cm-3||> 1’39||–|
|Weight of 20 chips||mg||320||–|
|Typical Moulding Temperature||ºC||270-290||–|
|Drying Conditions – Temperature||ºC||165-175||–|
|Drying Conditions – Time||h||5-6||–|
All proper are measured under laboratory conditions by the analytical method shown. Different methods or conditions of analysis may give different values. Purchased material will be accompanied by Certificate or Analysis, with representative average values of specified properties.
Food Contact Statement: PlastiVerd GLOBAL complies with the composition of requirements of the Regulation (EC) No 10/2011 and the EU directive on Packaging Waste (94/62/EC) and its amendments. For more information, contact your local Plastiverd representative
For queries or further information relating to this statement summary document please contact with Costumer Service